I'm having a problem pinging from client getting it's IP from FIOS router (192.168.1.x) to Mesh router (192.168.0.x).
To extend wireless i've turned off Wireless on FIOS router and have a EnGenius Mesh wifi (EMR3000), basically a router with 2 pods (3 pods including router). Installation is simple, the WAN port on Mesh router connects to an open Port on FIOS router. FIOS assigned it DHCP of 192.168.1.28, Mesh router set wifi up
with subnet 192.168.0.x.
The Mesh wifi works GREAT, i have the pods on differnt floors close to windows so it covers floor and outside area i need. It uses the same SSID, so as i move around property it seemlessly changes which pod i'm connected to based on signal strength. Previously i another setup as AP, which is ok.
My Problem: I cannot ping from FIOS subnet of 192.168.1.x into Mesh subnet of 192.168.0.x. BUT i can ping both subnets just fine from within the Mesh subnet?
Basic setup is FIOS Router (192.168.1.1) > Port 1 (192.168.1.28) "RJ45 cable" > Mesh WAN Port (192.168.0.1)
I can't figure out the routing to tell FIOS router that all traffic for subnet 192.168.0.x to traverse through 192.168.1.28. BUT there's a route somewhere since i can get to internet, watch video, etc from within Mesh.
Any help or if you need more info please feel free to ask.
Tom.